Attaching The Stand; Adjusting The Stand; Installing The Stand - HP Thin Client T740 Hardware Reference Manual

Attaching the stand

CAUTION:
attached to ensure proper airflow around the thin client.

Adjusting the stand

The stand can be adjusted into two configurations: square for the horizontal position and rectangular for the
vertical position.
Take the stand apart by removing the two short pieces connecting the two sides. Snap the sides to the outer
connection points on the short pieces for a square configuration or to the inner connection points for the
narrow configuration.

Installing the stand

The thin client can be used in either a tower or horizontal orientation with the stand included with the thin
client.
1. Remove/disengage any security devices that prohibit opening the thin client.
2. Remove all removable media, such as USB flash drives, from the thin client.
3. Turn off the thin client properly through the operating system, and then turn off any external devices.
4. Disconnect the AC power cord from the AC outlet and disconnect any external devices.
5. Adjust the stand, if necessary.
For instructions, go to
6. Attach the stand to the thin client.
Attach the stand to the bottom of the thin client to use the thin client in the tower orientation.
●
a.
6 Chapter 2 Setup
Unless the thin client is mounted with the HP Quick Release, it must be operated with the stand
Adjusting the stand on page
Turn the thin client upside down and locate the two screw holes in the grid on the bottom of
the thin client.
6.