Sidekey Board - HP Compaq Pro 4300 Maintenance & Serice Manual

Sidekey Board

The sidekey board is located on the bottom left side of the computer (viewed from behind) under the
main rear cover. It is secured with two Torx screws and has one connector.
The associated cable connects to the front power switch assembly. To remove this cable, you must
remove the stand bracket, disassembly of which is shown later in this document at
on page 75.
Figure 6-48
To remove the sidekey board:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the memory access panel (see
4. Remove the drive access panel (see
5. Remove the stand (see
6. Remove the optical drive (see
7. Remove the top panel (see
8. Remove the rear cover (see
Sidekey board location
33).
Stand on page
Optical Drive on page
Top Panel on page
Rear Cover on page
Preparing to Disassemble the Computer
Hinge Cover Panel on page
Memory Access Panel on page
Drive Access Panel on page
61).
40).
58).
62).
Stand bracket
34).
36).
38).
Sidekey Board 67