Table of Contents
Advertisement
Copyright © 2007, 2008 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
Install the RCA connector into the front
side of the chassis next to the 8-pin
valve base.
The white insulators are against the
chassis – Bend the GND pin on the
RCA inward so that it is away from the
chassis and you will be able to easily
solder to it.
We are now ready for the final
wiring
and
connections
MonoBlock...
We are going to add the 1K input
resistor that goes from the RCA input
to the 8 pin valve base.
If you bend in the style shown on the
left you will be able to fit it into position
above the valve base. Connect the
long end to the RCA input and the
other end to pin 4 of the valve base
which should be on the side closest to
the GND tag strip.
of
the
Page 45
Hide quick links:
Advertisement
Table of Contents
