Table of Contents
Advertisement
Copyright © 2007, 2008 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
The insert plate can now be screwed into position.
Now from the underside of the chassis we are going to
connect the capacitors into the power supply section.
The black Jensen capacitor with the 220uf 500V marking
will use the screw lugs.
Locate the + Lug and unscrew, then install the Prepared
Red cable into position – make sure that the metal lug does
not come in contact with the chassis.
Install the Black wire on the Negative side of the capacitor.
Solder the Black Wire to the GND BUS (silver wire section)
on the Hardwire Strip.
Solder the RED Wire into position to the 15K resistor.
The blue arrows opposite show where the wires are
connected – also see the following diagram for added
clarity...
Page 26
Hide quick links:
Advertisement
Table of Contents
