Table of Contents
Advertisement
Copyright © 2007, 2008 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
You will use the Countersunk M4
screws in the two holes as shown in
these pictures.
This picture shows the screws protruding through the
chassis – the next step is to install the heat sink into
position.
The Heat sink is installed.
Note the position of the little holes towards the back of the
chassis.
Page 13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Mono Block 300b/2A3 and is the answer not in the manual?