Configuring Ezviz Cloud P2P - HIKVISION DS-7108NI User Manual

User Manual of WIFI Network Video Recorder
SSID: the name of WIFI.
4. Select Working Channel and Security Type in the drop-down list.
5. If Security Type is set other one of the four types except Disable, select Encryption Type and input
Network Security Key.
WPA2-PSK and AES is more secure than WPA-PSK and TKIP. However, there may terminals which do
not support WPA2-PSK and AES. When you not sure whether terminals support or not, you can select
WPA-PSK/ WPA2-PSK and TKIP/AES to make NVR do the adaptive selection.
6. Click Apply to set up a wireless network.

11.2.2 Configuring EZVIZ Cloud P2P

Purpose:
EZVIZ Cloud P2P provides the mobile phone application and as well the service platform page to access and
manage your connected NVR, which enables you to get a convenient remote access to the surveillance system.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the Platform Access tab to enter the EZVIZ Cloud P2P Settings interface.
3. Check the Enable checkbox to activate this feature.
4. If required, select the checkbox of Custom and input the Server Address.
5. To turn the Enable Stream Encryption on, you can select its checkbox.
6. Enter the Verification Code of the device.
The Verification Code consists of 6 capital letters and is located at the bottom of the NVR.
7. Click the Apply to save the settings.
After configuration, you can access and manage the NVR by your mobile phone on which the EZVIZ Cloud P2P
application is installed or by the EZVIZ website (www.ezviz7.com).
For more operation instructions, please refer to the help file on the EZVIZ official website (www.ezviz7.com).
Figure 11. 4 EZVIZ Cloud P2P Settings Interface
131