Handling Exceptions Alarm - HIKVISION DS-7108NI User Manual

User Manual of WIFI Network Video Recorder

8.5 Handling Exceptions Alarm

Purpose:
Exception settings refer to the handling action of various exceptions.
Steps:
1. Enter Exception settings interface.
Menu > Configuration > Exception
2. Select the Exception Type in the drop-down list. Up to 6 kinds types are available.
•
HDD Full: The HDD is full.
•
HDD Error: Writing HDD error or unformatted HDD.
•
Network Disconnected: Disconnected network cable.
•
IP Conflicted: Duplicated IP address.
•
Illegal Login: Incorrect user ID or password.
•
Record Exception: No space for saving recorded files.
3. Check the checkbox of linkage action. Up to 4 linkage actions are available.
•
Audible Warning
Trigger an audible beep when an alarm is detected.
•
Notify Surveillance Center
Sends an exception or alarm signal to remote alarm host when an event occurs. The alarm host refers to the
PC installed with Remote Client.
The alarm signal will be transmitted automatically at detection mode when remote alarm host is configured.
Please refer to 11.2.6 Configuring Remote Alarm Host for details of alarm host configuration.
•
Send Email
Send an email with alarm information to a user or users when an alarm is detected.
Please refer to 11.2.10 Configuring Email for details of Email configuration.
•
Trigger Alarm Output
Trigger an alarm output when an alarm occurs.
You need to configure the dwell time and arming schedule for the alarm output.
a) Enter Alarm Output interface.
Menu > Configuration > Alarm > Alarm Output
b) Select an Alarm Output No..
Figure 8. 13 Exception Settings
102