Telnet Method - Comtrol DeviceMaster PRO Installation And Configuration Manual

Telnet Method

Telnet Method
80 - RedBoot Procedures
e. Click Send.
10. When the RedBoot> prompt appears (after approximately one minute for the
Bootloader and approximately three minutes for SocketServer), type go.
CCCCCCRaw load done: 542721 bytes read
Address range:
xyzModem - CRC mode, 4241(SOH)/0(STX)/0(CAN) packets, 8 tries
RedBoot> go
... Erase from 0x05030000-0x050c0000: .........
... Program from 0x00000000-0x00084801 at 0x05060000: ...
... Erase from 0x050f0000-0x05400000:
... Program from 0x007a0000-0x007b0000 at 0x053f0000: .
Note: In a few seconds, the ethernet and PWR LEDs cycle through a light sequence
once and then upgrade is complete.
11. If you updated SocketServer: type, fis list and press Enter at the RedBoot> prompt.
RedBoot> fis list
Name
FIS_directory 0x053F0000
default
RedBoot>
Note: You should see file information for a file called default. If you do not see this file,
repeat the process starting with
12. Reset the DeviceMaster by typing reset at the RedBoot> prompt.
RedBoot> reset
. . .Resetting
Note: In a few seconds the ethernet and PWR LEDs cycle through a light sequence
once and the update is complete.
13. Start your internet browser and enter the IP address of the DeviceMaster to verify
that the new version of SocketServer loads.
Use the following procedure to update the Bootloader or SocketServer with telnet to the
DeviceMaster.
Note: A TFTP server is required to perform firmware updates using Redboot.
1. Verify that you have the .bin file
2. Open a telnet session, type reset, and close the session.
00000000-00084800, Entry point:
FLASH addr Mem addr
0x053F0000
0x05030000 0x00000000
Step 6.
(Locating Software and Documentation on Page
DeviceMaster Installation and Configuration Guide: 2000506 Rev. B
00000000,
.
Length Entry point
0x00010000 0x00000000
0x00090000 0x00000000
10).