Comtrol DeviceMaster PRO Installation And Configuration Manual page 27

DeviceMaster Installation and Configuration Guide: 2000506 Rev. B
5. Verify that the PWR LED has completed the boot cycle and network connection for
the DeviceMaster RTS is functioning properly using the table below.
DeviceMaster RTS 16-Port (External Power Supply) LED Descriptions
Red LED on the front panel of the DeviceMaster is lit, indicating you have
power and it has completed the boot cycle.
Red Note: The LED flashes while booting and it takes approximately 15 seconds for
LED the Bootloader to complete the cycle. When the Bootloader completes
the cycle, the LED has a solid, steady light that blinks approximately
every 10 seconds.
The red LNK ACT LED is lit, indicating that you
LNK
have a working Ethernet connection.
ACT
If the red COL LED is lit, there is a network
COL
collision.
If the red 100 LED is lit, it indicates a working 100
MB Ethernet connection (100 MB network, only).
100
If the LED is not lit, it indicates a 10 MB Ethernet
connection.
Note: For additional LED information, go to the PWR/Status LED table on Page 97.
6. Go to Initial Configuration on Page 33
configure the DeviceMaster for use.
16-Port (DeviceMaster RTS - External Power Supply)
UP
for default network settings and how to
Hardware Installation - 27
10/100 NETWORK
LNK
ACT
COL
100
DOWN