Comtrol DeviceMaster PRO Installation And Configuration Manual page 29

DeviceMaster Installation and Configuration Guide: 2000506 Rev. B
6. Verify that the PWR LED has completed the boot cycle and network connection for
the DeviceMaster is functioning properly using the table below.
DeviceMaster PRO 16-Port LED Description
Red LED on the front panel of the DeviceMaster PRO is lit, indicating you
have power and it has completed the boot cycle.
Red
LED Note: The LED flashes while booting and it takes approximately 15
(Front seconds for the Bootloader to complete the cycle. When the
panel) Bootloader completes the cycle, the LED has a solid, steady light
that blinks approximately every 10 seconds.
The red LNK/ACT LED is lit, indicating
LNK/
that you have a working Ethernet
ACT
connection.
If the red COL LED is lit, there is a
COL
network collision.
If the red 100 LED is lit, it indicates a
working 100 MB Ethernet connection (100
100
MB network, only). If the LED is not lit, it
indicates a 10 MB Ethernet connection.
Note: For additional LED information, go to the PWR/Status LED table on Page 97.
7. Go to Initial Configuration on Page 33
configure the DeviceMaster for use.
16-Port (DeviceMaster PRO)
10/100 NETWORK
UP
for default network settings and how to
Hardware Installation - 29
LNK/
ACT
COL
100
DOWN