Comtrol DeviceMaster PRO Installation And Configuration Manual page 19

DeviceMaster Installation and Configuration Guide: 2000506 Rev. B
5. Plug the screw terminal power connector into the DeviceMaster.
6. Connect the power supply to a power source.
7. Plug the screw
terminal power
connector into JP1 on
the DeviceMaster by
aligning the scalloped
sides.
Note: Align the plug
properly. The
scalloped side
of the screw
terminal power
connector
should be
aligned with
the scalloped
side of the
power jack on
the unit.
8. Apply power to the DeviceMaster.
9. Verify the Status LED has completed the boot cycle and network connection for the
DeviceMaster is functioning properly using the table below.
The LEDs are located between the RJ45 connector and the power terminal block.
When lit, the amber Status LED (D1) on the DeviceMaster
indicates the devices is fully powered and has completed
the boot cycle.
Status Note: The Status LED flashes for approximately 15 seconds
When lit, the red Link/Act LED (D2) indicates a working
Link/
Ethernet connection.
Act
When lit, the red Duplex (D3) LED indicates full-duplex
Duplex
activity.
When lit, the red 100 (D4) LED indicates a working 100 MB
Ethernet connection (100 MB network, only). If the LED is
100
not lit, it indicates a 10 MB Ethernet connection.
Note: For additional LED information, go to the Status LED table on
Page 97.
10. Go to Initial Configuration on Page 33
configure the DeviceMaster for use.
Connecting the Power and Verifying Installation
LED Descriptions
while booting. When the Bootloader completes the
cycle, the LED has a solid, steady light that blinks
approximately every 10 seconds.
for default network settings and how to
LEDs
JP1
Hardware Installation - 19