Comtrol DeviceMaster PRO Installation And Configuration Manual page 31

Caution
DeviceMaster Installation and Configuration Guide: 2000506 Rev. B
3. Connect the DeviceMaster port labeled 10/100 NETWORK to the same Ethernet
network segment as the host PC using a standard network cable.
If you plan on using the NS-Link device driver, make sure that you do not connect
RS-422/485 devices until the appropriate port interface type has been configured
in the driver. The NS-Link default port setting is RS-232.
4. Apply power to the DeviceMaster by connecting the appropriate power cord into the
power socket on the DeviceMaster, plugging the power cord into a power source, and
turning on the power switch.
5. Verify that the Status LED has completed the boot cycle and network connection for
the DeviceMaster is functioning properly using the table below.
16/32-Port (Internal Power Supply) LED Descriptions
The amber Status LED on the device is lit, indicating you have power and it
has completed the boot cycle.
Note: The Status LED flashes while booting and it takes approximately 15
Status
seconds for the Bootloader to complete the cycle. When the
Bootloader completes the cycle, the LED has a solid, steady light that
blinks approximately every 10 seconds.
The red LNK/ACT LED is lit, indicating that you have a
LNK/
working Ethernet connection.
ACT
If the red Duplex LED is lit, it indicates full-duplex
Duplex
activity.
If the red 100 LED is lit, it indicates a working 100 MB
Ethernet connection (100 MB network, only). If the LED
100
is not lit, it indicates a 10 MB Ethernet connection.
Note: For additional LED information, go to the Status LED table on Page 97.
6. Go to Initial Configuration on Page 33
configure the DeviceMaster for use.
16/32-Port Rack Mount Models (Internal Power Supply)
DeviceMaster RTS
Page 94
Larger picture,
Larger picture, Page 94
DeviceMaster Serial Hub
Larger picture, Page 94
for default network settings and how to
LNK/
ACT
Duplex
100
10/100 ETHERNET
Hardware Installation - 31