Comtrol DeviceMaster PRO Installation And Configuration Manual page 81

DeviceMaster Installation and Configuration Guide: 2000506 Rev. B
3. Open a new telnet session and enter the DeviceMaster IP address.
$ telnet 192.168.250.250
Trying 192.168.250.250...
Connected to 192.168.250.250.
Escape character is '^]'.
4. Enter the webserver password.
Note: Press the Enter key if you have not programmed a password.
Password:
*********************************************
**
** Comtrol DeviceMaster Bootloader Version 3.05
** RedBoot(tm) environment - built 08:13:02, Apr
** Platform: Comtrol DeviceMaster (ARM 7TDMI)
** Portions Copyright (C) 2000. Red Hat, Inc.
** Portions Copyright (C) 2001-2008 Comtrol Corp.
*********************************************
FLASH: 64 blocks of 65536 bytes each
FLASH: 4194304 bytes (0x05000000 - 0x05400000)
RAM: 8126464 bytes (0x00000000 - 0x007c0000)
RedBoot>
5. At the Redboot prompt: type dis and press Enter to disable the Bootloader.
RedBoot>dis
Loading disabled
6. Verify that the system responds with an Loading disabled message.
7. Load the file from a TFTP server using the following command and press the Enter
key:
load -r -b 0 -h <TFTP-Server_IP_Addr> <Downloaded_File_Name>
Note: The default IP address is: 192.168.250.250.
RedBoot> load -r -b 0 -h 192.168.250.1 1800110.bin
CCCCRaw load done: 139521 bytes read
Address range: 00000000-00022100, Entry point: 00000000.
xyzModem - Cksum mode, 1091(SOH)/0(STX)/0(CAN) packets, 6 retries
RedBoot>
8. When the RedBoot> prompt appears (after approximately one minute if you are
uploading the Bootloader and approximately three minutes if you ware uploading
SocketServer), type go.
RedBoot>go
If uploading Bootloader: In a few seconds the ethernet and PWR LEDs cycle through
a light sequence once and the update is complete.
Default IP Address
4 2008
RedBoot Procedures - 81
Telnet Method