Operation - Worx WX312 Safety And Operating Manual

OPERATION

NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood,
metal and plastic.
1. AUXILIARY HANDLE (See Fig. A)
Slide the handle onto the drill and rotate to the desired
working position. To clamp the auxiliary handle
rotates the handgrip clockwise. To loosen the auxiliary
handle rotate the hand grip anti-clockwise. Always use
the auxiliary handle.
WARNING! Always check and rotate the
handle tightly before using to avoid any
accident.
2. INSTALLING THE DEPTH GAUGE
(See Fig. B)
The depth gauge can be used to set a constant depth
to drill. To use the depth gauge, loosen the handle by
rotating the bottom section of handle anti-clockwise.
Insert the depth gauge through hole in handle. Slide
the depth gauge to required depth and tighten fully.
3. INSERTING A TOOL INTO CHUCK
(See Fig. C1, C2, C3)
KEY CHUCK (1) (WX312)
Remove chuck key from key storage tab at base of drill
handle, place key into chuck, turn key anti-clockwise to
undo/loosen chuck, inset drill/tool and firmly tighten
chuck by turning key clockwise. Remove key and
replace in storage tab at base of drill handle.
(See Fig. C1)
Impact drill
1
2
a
C2
2
1
C3
1
2
D
E
A
B
C1
WX312 WX312.1
7