Worx WX312 Safety And Operating Manual
Hide thumbs
Also See for WX312:
- Operating manual (14 pages) ,
- Manual (104 pages) ,
- Original instructions manual (84 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Worx WX312
Summary of Contents for Worx WX312
- Page 1 SAFETY AND OPERATING MANUAL Impact drill WX312 WX312.1...
-
Page 2: General Power Tool Safety Warnings
When operating a power tool connected and properly used. Use outdoors, use an extension cord of these devices can reduce dust-related suitable for outdoor use. Use of a cord hazards. suitable for outdoor use reduces the risk of Impact drill WX312 WX312.1... -
Page 3: Additional Safety Points For Your Drill
This will as the drill bit is rotating. ensure that the safety of the power tool is Do not grasp the tool or place your maintained. hands too close to the spinning Impact drill WX312 WX312.1... - Page 4 16. Position the tether clear of rotating bit. Do not wrap the tether around your arm or wrist. If you lose control and have the tether wrapped around your arm or wrist, it may entrap you and cause injury. Impact drill WX312 WX312.1...
- Page 5 Impact drill WX312 WX312.1...
-
Page 6: Technical Data
Depth gauge Chuck key (WX312) HSS drill bit : 5, 6, 8mm ( Each 1 pc WX312.1) Masonry drill bit : 6, 8,10mm (Each 1 pc WX312.1) We recommend that you purchase your accessories from the same store that sold you the tool. -
Page 7: Operation
3. INSERTING A TOOL INTO CHUCK (See Fig. C1, C2, C3) KEY CHUCK (1) (WX312) Remove chuck key from key storage tab at base of drill handle, place key into chuck, turn key anti-clockwise to undo/loosen chuck, inset drill/tool and firmly tighten chuck by turning key clockwise. - Page 8 KEYLESS CHUCK (9) (WX312.1) First pull the locking sleeve (a) backward until you hear a “click” sound. Then, while holding the locking sleeve, rotate and loosen the front section of the chuck to open the chuck jaws. Insert the drill bit into...
- Page 9 8. HAMMER OR DRILLING CONTROL (See G) When drilling masonry and concrete push the drill/ impact action selector switch into the hammer position “ ”. When drilling wood, metal, plastic push the switch into the drill position “ ”. Impact drill WX312 WX312.1...
-
Page 10: Working Hints For Your Drill
This is normal and will not damage your power tool. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Impact drill WX312 WX312.1... - Page 12 Copyright © 2014, Positec. All Rights Reserved. 2SDI104PK11002A4...