Intended Use; Operation - Worx D-LITE WX104 Original Instructions Manual

WARNING: The vibration and noise emissions during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool is
used especially what kind of workpiece is processeddependant
on the following examples and other variationson how the
tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use ofthe correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and these
instructions.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed.
WARNING: To be accurate, an estimation of exposure
EN
level in the actual conditions of use should also take
account of all parts of the operating cycle such as the times
14 when the tool is switched off and when it is running idle but
not actually doing the job. This may significantly reduce the
exposure level over the total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration
and noise accessories.
Plan your work schedule to spread any high vibration tool use
across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.

INTENDED USE

The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal and plastic.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Charging the battery
ASSEMBLY
CHUCK ADJUSTMENT
Warning: Always lock off trigger
switch and disconnect tool from
power source when changing
accessories. Make sure the forward/
reverse rotation control is in middle lock
off position. Always ensure the bit is
secure before starting the tool. Damage to
the Chuck or a loose bit may cause
possible personal injury.
Removing the bits
Inserting the bits

OPERATION

Forward/reverse rotation control
Warning: Never change the
direction of rotation when the
chuck is rotating, wait until it
has stopped!
Operating the on/off switch
Warning: Do not operate for long
periods at low speed because
excess heat will be produced
internally.
FIGURE
See Fig. A
See Fig. B1
See Fig. B2
See Fig. C1,
C2, C3
See Fig. D