Worx WX312 Safety And Operating Manual page 4

chuck or drill bit. Your hand may be
lacerated.
10. When installing a drill bit, insert the
shank of the bit well within the jaws
of the chuck. If the bit is not inserted
deep enough, the grip of the jaws over
the bit is reduced and the loss of control
is increased.
11. Do not use dull or damaged bits
and accessories. Dull or damaged bits
have a greater tendency to bind in the
workpiece.
12. When removing the bit from the
tool avoid contact with skin and
use proper protective gloves when
grasping the bit or accessory.
Accessories may be hot after prolonged
use.
13. Check to see that keys and adjusting
wrenches are removed from the drill
before switching the tool "ON". Keys
or wrenches can fly away at high velocity
striking you or bystander.
14. Do not run the dill while carrying it
at your side. A spinning drill bit could
4
become entangled with clothing and
injury may result.
15. Avoid bouncing and snagging the
wheels, discs or brushes especially
when working corners, sharp edges,
etc. This can cause loss of control and
kickback.
16. Position the tether clear of rotating
bit. Do not wrap the tether around
your arm or wrist. If you lose control
and have the tether wrapped around your
arm or wrist, it may entrap you and cause
injury.
Impact drill
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
RCM approval mark
WX312 WX312.1