Operation; Problem Solution - Worx WX102.X Series Manual

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Checking the battery charge condition
NOTE: Fig. A1 only applies for the battery
pack with battery indicator light.
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and
disconnect tool from power source when changing
accessories. Always ensure the bit is secure before
starting the tool. Damage to the Chuck or a loose bit may
cause possible personal injury.
10
-- Removing the bits
-- Inserting the bits
-- Assembling the belt hook and bit clip

OPERATION

Forward/Reverse Rotation Control
WARNING: Never change the
direction of rotation when the chuck
is rotating, wait until it has stopped!
TWO-SPEED GEAR CONTROL
WARNING: To prevent gear damage,
always allow the chuck to come to a
complete stop before changing the
direction of rotation.
TORQUE ADJUSTMENT
Drilling, Screw driving
Operating the On/Off switch
WARNING: Do not operate for long
periods at low speed because
excess heat will be produced internally.
20V Cordless Drill Driver
LED light indicator
Before operation, the LED light will be
activated when the On/Off switch is
slightly depressed.
WARNING: To turn on the light,
press the On/Off switch and make
sure the Forward/Reverse Rotation
Control is on right/left position.
The tool and battery are equipped with a
protection system. When the LED Light
FIGURE
is quickly flashing 60 seconds and turn
off, the system will automatically cut off
power to the tool to extend battery life.
The tool will automatically stop during
See Fig. A1
operation if the tool and/or battery
are placed under one of the following
conditions:
See Fig. A2
• Overloaded: The tool is operated
in a manner that causes it to draw an
See Fig.A3
abnormally high current. In this situation,
See Fig.A4 release the Trigger Switch on the tool
and stop the application that caused the
tool to become overloaded. Then pull the
Trigger Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In this
situation, let the Tool and Battery cool
before pulling the Trigger Switch again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool
See Fig. B1
will not operate. In this situation, remove
See Fig. B2
and recharge the Battery.
See Fig. C1,
C2, C3, C4

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
See Fig. D1,
The forward/reverse rotation control, which is on top of
D2, D3
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill
will start to rotate. Check that the battery is charged and
properly connected to the tool.
See Fig. E
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring.
Find the torque adjusting ring between the chuck and the
See Fig.
drill body. Position 1 is the lowest torque (screw driving
F1, F2
force) and position 18 is the highest torque (screw driving
force). Position is for drill operation. Regulate the torque
adjusting ring to a higher position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY PACK WORKING
See Fig. G
TIMES
Charging time problems, as above, and having not used a
battery pack for a prolonged time will reduce the battery
pack working time. This can be corrected after several
See Fig. G
EN