Assembly And Operation; Problem Solution - Worx WX101.7 Manual

We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
ASSEMBLY AND
OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery
10
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
Warning: Always lock off trigger switch and
disconnect tool from power source when
changing accessories. Always ensure the bit is secure
before starting the tool. Damage to the Chuck or a
loose bit may cause possible personal injury.
-- Removing the bits
-- Inserting the bits
OPERATION
Forward/Reverse Rotation Control
Warning: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
Warning: To prevent gear
damage, always allow the chuck
to come to a complete stop before
changing the direction of rotation.
20V Cordless Drill Driver
TORQUE ADJUSTMENT
Drilling, Screw driving
Operating the On/Off switch
Warning: Do not operate for
long periods at low speed
because excess heat will be produced
internally.
LED light indicator
Before operation, the LED light will be
activated when the On/Off switch is
slightly depressed.
make sure the Forward/Reverse
Rotation Control is on right/left
position.
The tool and battery are equipped
with a protection system. When
the LED Light is quickly flashing 60
seconds and turn off, the system will
automatically cut off power to the
FIGURE
tool to extend battery life. The tool will
automatically stop during operation
if the tool and/or battery are placed
under one of the following conditions:
See Fig. A1
• Overloaded: The tool is operated
in a manner that causes it to draw
See Fig. A2,
an abnormally high current. In this
A3,
situation, release the Trigger Switch
on the tool and stop the application
See Fig. A4
that caused the tool to become
overloaded. Then pull the Trigger
Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In
this situation, let the Tool and Battery
cool before pulling the Trigger Switch
again.
• Low battery voltage: The
remaining Battery capacity is too low
See Fig. B1
and the tool will not operate. In this
situation, remove and recharge the
See Fig. B2
Battery.

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON WHEN
See Fig. C1,
YOU PRESS THE SWITCH?
C2, C3
The forward/reverse rotation control, which is on
top of the trigger, is positioned in the lock function.
Unlock the forward/reverse rotation control by
putting it into the required rotation position. Push
the trigger and the drill will start to rotate. Check
that the battery is charged and properly connected
See Fig. D
to the tool.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Warning: To turn on the light,
press the On/Off switch and
See Fig.
E1, E2
See Fig. F
See Fig. F
EN