Operation Instructions - Worx WX121 Series Manual

use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days
OPERATING INSTRUCTIONS
4.
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
This tool is used to drive screws or drill holes in
wood, metal and plastic, and it is used to drill holes in
lightweight concrete or brick walls.
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
Remove/Install the battery pack
charger the battery pack
CHUCK ADJUSTMENT
WARNING: Always lock off trigger
switch and disconnect tool from
power source when changing
accessories. Always ensure the bit is
secure before starting the tool.
Damage to the Chuck or a loose bit
may cause possible personal injury.
Removing the bits
Inserting the bits
OPERATION
Forward/reverse rotation control
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
FIGURE
See Fig. A1
See Fig. A2
EN
15
See Fig. B1
See Fig. B2
See Fig.
C1,C2,C3
See Fig. D