Worx WX312 Safety And Operating Manual page 8

2
a
C2
1
C3
8
1
D
E
Impact drill
1
2
2
KEYLESS CHUCK (9) (WX312.1)
First pull the locking sleeve (a) backward until you
hear a "click" sound. Then, while holding the locking
sleeve, rotate and loosen the front section of the
chuck to open the chuck jaws. Insert the drill bit into
the chuck jaws, and while holding the locking sleeve,
rotate and tighten the front section in the opposite
direction. Ensure that the drill bit is in the center of the
chuck jaws. Finally, push the locking sleeve forward
until you hear a "click" sound. Your drill bit is now
A
locked in the chuck. (See Fig. C2,C3)
4. ON/OFF SWITCH
Depress the switch to start the tool and release it to
stop your tool.
5. SWITCH LOCK-ON BUTTON (See Fig. D)
Depress on/off switch then lock-on button, release on/
off switch first and lock-on button second. Your switch
is now locked on for continuous use. To switch off
your tool just depress and release the on/off switch.
6. VARIABLE SPEED CONTROL
B
(See Fig. E)
Adjust the variable speed control to increase or
decrease the speed according to the material and
accessory to be used (also possible during no load
operation). Low speed will provide low torque and
high speed gives higher torque.
C1
WX312 WX312.1