Assembly And Operation - Worx WU175 Manual

OPERATING INSTRUCTIONS
Note: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Checking the battery charge
condition
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
Warning: Always lock off trigger
switch and disconnect tool from
power source when changing
accessories. Always ensure the bit
is secure before starting the tool.
Damage to the Chuck or a loose bit
may cause possible personal injury.
Removing the bits
Inserting the bits
Assembling the belt hook and bit
clip
OPERATION
FORWARD/REVERSE ROTATION
CONTROL
Warning: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
Drilling
Screwdriving or Hammer Drilling
OPERATING THE ON/OFF SWITCH
Warning: Do not operate for long
periods at low speed because excess
heat will be produced internally.
LED LIGHT INDICATOR
Before operation, the LED light
will be activated when the On/
Off switch is slightly depressed,
FIGURE
and will automatically turn off 20
seconds after the On/Off switch is
released.
See Fig. A1
The tool and battery are equipped
with a protection system. When
See Fig. A2
the LED Light is quickly flashing 3
seconds and turn off, the system
See Fig. A3
will automatically cut off power
to the tool to extend battery life.
See Fig. A4
The tool will automatically stop
during operation if the tool and/or
battery are placed under one of the
following conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw
an abnormally high current. In this
situation, release the Trigger Switch
on the tool and stop the application
that caused the tool to become
overloaded. Then pull the Trigger
Switch again to restart.
See Fig. B1
• Overheated: Under the condition
above, if the tool does not
See Fig. B2
start, the Tool and Battery are
See Fig. C1,
overheated. In this situation, let the
C2, C3, C4
Tool and Battery cool before pulling
the Trigger Switch again.
• Low battery voltage: The
remaining Battery capacity is too
low and the tool will not operate. In
this situation, remove and recharge
See Fig.D1,
the Battery.
D2, D3
Warning:To turn on the light,
press the On/Off switch and make
sure the Forward/Reverse Rotation
See Fig. E
Control is on right/left position.
See Fig. F
See Fig. G
11