Building Different Fires For Different Needs - Osburn 2200 Installation And Operation Manual

2200 Installation and Operation Manual
heat from the exhaust. You will notice that as you reduce the air setting, the flames slow down.
This is your indication that the stove is burning at its peak efficiency.
If the flames get small and almost disappear when you turn down the air, you have turned down
the air too early, or your firewood is wetter than it should be. With good fuel and correct air
control use, the flames should slow down, but should stay large and steady, even as the air supply
is reduced.
4.3.6 BUILDING DIFFERENT FIRES FOR DIFFERENT NEEDS
Using the air control is not the only way to match the stove's heat output to the heat demand.
Your house will need far less heat in October than in January to be kept at a comfortable
temperature. If you fill the firebox full in fall weather, you will either overheat the space or turn
the stove down so much that the fire will be smoky and inefficient. Here are some suggestions for
building fires to match different heat demand.
4.3.6.1 Small Fires to Take the Chill Off the House
To build a small fire that will produce a low heat output, use small pieces of firewood and load
them crisscross in the firebox. The pieces should be only 3" to 4" in diameter. After raking the
coals, you can lay two pieces parallel to each other corner to corner in the firebox and lay two
more across them in the other direction. Open the air control fully and only reduce the air after
the wood is fully flaming. This kind of fire is good for mild weather when you are around to tend
the stove and should provide enough heat for four hours or more. Small fires like this are a good
time to use softer wood species so there will be less chance of overheating the house.
4.3.6.2 Long Lasting Low Output Fires
Sometimes you will want to build a fire to last up to eight hours, but don't need intense heat. In
this case use soft wood species and place the logs compactly in the firebox so the pieces are
packed tightly together. You will need to fire the load hot for long enough to fully char the log
surfaces before you can turn the air down. Make sure the fire is flaming brightly before leaving the
fire to burn.
_ _____________________________________________________________________________ 1 9