Emergencies; Hazard Warning Lamp; Vehicle Does Not Start - Checks - Mahidra TUV 300 Owner's Manual

13 EMERGENCIES

13.1 Hazard Warning Lamp

The hazard warning lamp switch is located above the AC controls
on the instrument panel. Use the hazard warning lamp when your
vehicle is stationary or to warn other road users to be cautious
while passing your vehicle.
To turn the hazard warning lamp ON, press the switch in. All the
turn signal lamps flash. To turn OFF, press the switch again.
A/C
The turn lamps do not work when the hazard warning lamps
are operational.
Hazard lamps are also switched ON during the following
conditions;
© Copyright Mahindra & Mahindra Ltd. 082015
A/C ECO
U42H18
• Crash — Hazard would be turned on for 30 mins
• Panic Braking — When the vehicle is running above 100
kmph and panic/sudden brakes are applied, hazard will turn
on for 5 sec
• Vehicle break down warning bonnet open — The vehicle
break down warning would be enabled only when bonnet
switch changes from close to open condition at vehicle
unlocked condition
Pressing the hazard switch twice deactivates this feature.

13.2 Vehicle Does not Start - Checks

Before making these checks, make sure you have followed the
correct starting procedure and that you have sufficient fuel.
If the engine is not cranking or is cranking too slowly/ intermittently
Check that the battery terminals are tight and clean
1.
If the battery terminals are firmly fastened, turn the interior
2.
lamps ON
If the lamps do not illuminate, glow dim or go OFF when the
3.
starter is cranked, the battery is weak or discharged. Try jump
starting. Follow 'Jump starting' instructions given later in this
chapter
Check the fuses in the Engine Compartment Fuse Box and
4.
Central Fuse Box
EMERGENCIES
13-1