Temperature Gauge; Fuel Level Gauge - Mahidra TUV 300 Owner's Manual

Gear selection display displays the shifter position in Numerics
1,2,3,4,5.
AC meter is displayed only when the ignition is ON. To cycle
between trip A & B and AC meter, press and release MODE (B)
button for few seconds.

8.15.6 Temperature Gauge

The engine coolant temperature bar graph functions only when the
ignition is switched ON. It indicates the instantaneous engine
coolant temperature. The coolant temperature varies with changes
in weather, load on engine and driving pattern. LCD bar rises from
Cold (C) towards Hot (H).
© Copyright Mahindra & Mahindra Ltd. 082015
At normal operating temperature, 4 bars are displayed in the LCD
bar graph. The high engine coolant temperature lamp along with all
8 bars blink when the temperature reaches 110 o C. And when the
temperature is 119 o C, the temperature warning lamp and all 8
bars are permanently ON. In such situations switch OFF the AC and
observe any improvements in the temperature gauge. If not, stop
the vehicle and allow the engine to cool down. Check the coolant
level in the coolant reservoir and top-up if required. If the engine is
still overheating, contact your nearest Authorized Mahindra Dealer.

8.15.7 Fuel Level Gauge

The fuel level bar graph functions only when the ignition is switched
ON. It gives the status of the fuel level in the fuel tank. F indicates
the tank is full (60 liters), E indicates the tank in empty. The amount
of fuel required to fill the tank up may be less than the specified tank
U42H39
capacity, as a small amount of reserve fuel always remains in the
tank.
Never remove the degassing tank cap when the engine is hot.
The engine coolant is under pressure and could splash on to
skin/eyes causing severe burns. Wait for the engine to cool
down before adding coolant to the reservoir.
Do not continue driving the vehicle with a overheated engine.
This will lead to damage of engine components and engine
seizure.
FEATURES AND CONTROL
8-27