Mahidra TUV 300 Owner's Manual page 100

FEATURES AND CONTROL
8.11.8 Wipe/Wash
Pull/Lift the wiper control stalk towards the steering wheel from
any position to activate the front wipe/wash function. Washer fluid
is sprayed on the front windshield and the wipers wipe the
windshield 3 times after the washer spray is stopped and wipe once
after 4 sec. Hold the stalk in position for continuous spray of
washer fluid.
The rear windshield wash & wipe operates 3 to 4 times or as long
as the stalk end is turned/rotated to wash détente. Wiping will
continue for few seconds after releasing the stalk end switch.
8-18
Washer fluid is taken from the reservoir in the engine
U42H45
compartment.
In the front, a single nozzle with twin adjustable washer jets is
provided on the applique below the wiper. Using a pin, the eye ball
jets can be adjusted precisely for direction. Always direct the
washer jet to hit the middle of the windshield. This will enable the
wiper blade to wipe the complete width of the windshield.
U42H46
U42H25
© Copyright Mahindra & Mahindra Ltd.082015