Getting Started; Installing The Software; Evaluation Board Setup Procedures - Analog Devices EVAL-AD5592RSDZ User Manual

UG-753

GETTING STARTED

INSTALLING THE SOFTWARE

The evaluation kit for the AD5592R
software on a CD. The software is compatible with
Windows® XP, Windows Vista (32-bit version), and Windows 7
(32- and 64-bit versions). The software must be installed before
connecting the SDP-B board to the USB port of the PC to
ensure that the SDP-B board is recognized when it is connected
to the PC.
To install the software, take the following steps:
1. Start the Windows operating system and insert the CD.
2. The installation software opens automatically. If it does not
open automatically, run the setup.exe file from the CD.
includes self-installing
Rev. 0 | Page 4 of 13
EVAL-AD5592RSDZ User Guide
3. After installation is complete, power up the evaluation
board as described in the Power Supplies section.
4. Connect the evaluation board to the
connect the SDP-B board into the PC using the USB cable
included in the box.
5. When the software detects the evaluation board, proceed
through any dialog boxes that appear to finalize the installation.

EVALUATION BOARD SETUP PROCEDURES

1. Connect the evaluation board to the
connect the USB cable from the
2. Power the SDP-B and evaluation boards by connecting 6 V
to the J3 connector.
SDP-B board, and
SDP-B board, and
SDP-B board to the PC.