Fast Activation Procedure; B.2.1 Serial Number; B.2.2 View Currently Installed Features; B.2.3 Enter Access Codes - Comtech EF Data CDM-740 Installation And Operation Manual

CDM-740 Advanced Satellite Modem

FAST Activation Procedure

Sect. 1.3.10 in Chapter 1. INTRODUCTION shows the FAST and FAST-accessible hardware
options available for the CDM-740.
B.2 FAST Activation Procedure
The FAST options are linked to three option registers – Word1, Word2, and Word3. When an
unlock FAST code is obtained from Comtech EF Data it will be for a specific register.

B.2.1 Serial Number

Obtain the Modem serial number as follows:
a) From the front panel main menu,
b) The Modem motherboard Serial Number is displayed on the bottom line, to the left.
c) Record serial number:

B.2.2 View currently installed features

To view the currently installed features, proceed as follows:
a) From the front panel main menu,
b) From the
c) Scroll through the Modem Options using the up and down arrow keys (
note which options are 'Installed' or 'Not Installed'. Any that are 'Not
Installed' may be purchased as a FAST upgrade.
Contact a Comtech EF Data sales representative to order features. You will be asked to provide
the Modem Serial Number. Comtech EF Data Customer Support personnel will verify the order
and provide an invoice and instructions, including a 20-character configuration code.

B.2.3 Enter Access Codes

Enter the access codes as follows:
a) Press [CLEAR] to return to the
b) Select #:
c) Use the arrow keys (
d) Press [ENTER].
If everything has been entered correctly, the display will show "
and the modem resets to its default configuration. If the code was not considered valid, the
message "FAILED TO
SELECT: FAST OPTIONS
SELECT: FAST
(where # is Register #1, #2, or #3), then press [ENTER].
SET
) to carefully enter the 20-character configuration code.
▲▼◄ ►
CONFIGURE. RE-ENTER CODE
B–2
then press [ENTER].
SELECT: FAST,
, then press [ENTER].
SELECT: FAST
menu, select
VIEW
OPTIONS
CONFIGURED CORRECTLY
" will be shown.
Revision 0
MN-CDM740
, then press [ENTER].
), and
▲▼
menu.
"