Preparing To Spray - WAGNER FLEXiO 990 Owner's Manual

note: Before spraying, you will need to prime the
system (deliver material from the container to the
spray nozzle via the paint hose). Follow the steps
below.
You Will Need:
• Waste bucket
• Drop cloths to protect floors and furnishings from
overspray

Preparing to Spray

1. Point the spray nozzle into the side of an empty
waste container.
Squeeze and hold the trigger for the next steps.
note: Point the sprayer to the side of the waste
container to minimize overspray.
2. Turn the ON/OFF switch to ON.
Material will begin to flow from the container into
the paint hose. Air will blow from the spray nozzle.
3. Continue to squeeze the trigger until the material is
flowing freely from the spray gun.
The system is now primed and you are ready to
spray.
note: If the sprayer has been used before, some
cleaning solution may be left in the paint hose from
previous cleanings. Squeeze the trigger until all air
and cleaning solution is purged from the hose and
material is spraying from the nozzle.
note: The fluid pump will cycle ON and OFF while
spraying to regulate pressure. This is normal.
© Wagner Spray Tech - All Rights Reserved
Preparing to Spray
1
2
3
English
On
7