Setup - WAGNER FLEXiO 990 Owner's Manual

Before you begin
nEVER point the spray gun at any part
of the body.
IMPORTanT: Make sure the power cord is
unplugged.

Setup

note: Make sure the system is placed in a level, clean
surface. Follow these instructions for both one-gallon
and five-gallon containers.
1. Lift up the suction tube holder as far as it will go.
2. Position the material container next to the pump
assembly as shown. The container handle (a) should
be vertical and placed in between the two suction
tube guides.
Slide the suction tube holder (b) down until it
touches the top of the material container. The
container is now secured to the pump and the entire
unit can be carried by the container handle.
IMPORTanT: The container handle must be placed
between the two suction tube guides, or the
container will tip when carried due to the added
weight of the pump assembly.
3. Place the suction tube back into position in the
suction tube guide. Make sure the tube reaches the
bottom of the material container.
note: If working on a ladder, use the belt clip. This
accessory provides 1) a place to hook the sprayer to
free your hands and 2) a place to attach the spray hose
to reduce the pull on your arm.
4. Guide the cord (c) behind the tab (d) on the clip
(the paint hose does not need to be secured, as it is
attached to the cord). The cord should be attached
near the turbine plug (e).
5. Attach the belt clip to yourself (it is recommended
that it be secured to waistband of your pants).
6. If necessary, hook the spray gun into the belt clip
with the attachment (f).
4
d c
e
English
6
Setup
5
Watch Setup:
www.flexio990/setup
1
2
b
a
3
6
© Wagner Spray Tech. - All Rights Reserved
f