WAGNER FLEXiO 990 Owner's Manual page 20

Cleanup - continued
Cleaning the nozzle
1. Make sure power cord is unplugged.
Push the tab below the trigger, twist and separate the
nozzle from the turbine. Wipe the exterior of the cup
and nozzle until clean.
2. Unscrew the nut and remove the air cap and nozzle.
3. Remove the parts as shown*. Clean all parts with a
cleaning brush and the appropriate cleaning solution.
Reassemble all parts when clean**.
4. Clean the air vent (c) on the suction tube with a soft
bristled cleaning brush.
5. Clean the rear of the nozzle (d) with the appropriate
cleaning solution. Use a thin layer of petroleum jelly
to lubricate the O-ring (e).
* The red nozzle seal may become stuck inside the spray
nozzle when the nozzle is removed. If this occurs,
make sure to pull it out.
** It is important that the nozzle seal inside the nozzle
be re-installed properly. Make sure the cup side of the
seal (the side with the groove) is facing out towards
the front of the nozzle. Improper installation will
cause leakage.
note: Once cleanup steps are complete, see
"Maintenance" section in the main unit instruction
manual.
3
English
20
4
(c)
*
(Control Finish Nozzle only)
1
2
5
**
Groove
© Wagner Spray Tech. - All Rights Reserved
e
d