7-24
Overview
7.1.18 static-channel-group
Interface Config commands
Use this command to to add an interface to a static channel group.
Syntax
static-channel-group <1-4>
Parameters
<1-4>
Usage Guidelines
This command aggregates individual giga port's into a single aggregate link to provide a larger bandwidth.
Static channel group is used to provide additional bandwidth in multiples of 1Gbps on the switch. All MAC
layer and higher protocols see only the static channel group (aggregate link) rather than the individual ports
that comprise it.
Example
RFS7000(config-if)#static-channel-group 2
RFS7000(config-if)#
Static channel group to associate the link with.