Switchport - Motorola RFS7000 Series Reference Manual

7.1.19 switchport

Interface Config commands
Use this command to set switching mode characteristics for the selected interface. The mode can be either
access or trunk.
NOTE The
its confiugration and has only VLAN 1 set to allowed.
Syntax
switchport(access|mode|trunk)
switchport access vlan <1-4094>
switchport mode(access|trunk)
switchport trunk(allowed|native)
switchport trunk allowed vlan(add|none|remove)<VLAN_ID>
switchport trunk native(tagged|vlan<1-4094>)
Parameters
access (vlan) <1-4094>
mode (access|trunk)
trunk (allowed|native)
trunk allowed (vlan)
(add|none|remove)
<VLAN_ID>
trunk native (tagged |
vlan <1-4094>)
Usage Guidelines
The interface ge1-ge4 can be configured either as trunk or in access mode. Interface when configured as trunk
allows packets from the given list of VLANS that is added to the trunk. Inerface when configured as access
will allow packets only from the native VLANs.
interface earlier configured as a trunk with all VLAN's allowed on it looses
ge
Sets access mode characteristics.
• vlan <1-4094> – Sets the VLAN when an interface is in access mode.
Sets the mode of the Layer2 interface.
• access – Sets the Layer2 interface as access.
• trunk – Sets the Layer2 interface as trunk.
Sets trunking mode characteristics.
• allowed – Sets trunking mode allowed VLAN characteristics.
• native – Sets native trunking characteristics.
Sets trunking mode allowed VLAN characteristics.
• vlan – Sets the allowed VLANs.
• add – Adds a VLANs to the current list.
• none – Restricts VLANs to Xmit/Rx through the Layer2 interface.
• remove – Removes VLANs from the current list.
• VLAN_ID – The list of the VLAN IDs to be added/removed. For example,
10-20,25,30-35.
Sets native trunking characteristics.
• tagged – Sets the native VLAN for classifying untagged traffic.
• vlan <1-4094> – Sets the native VLAN for classifying untagged traffic
when the interface is in trunking mode.
7-25