Port-Channel - Motorola RFS7000 Series Reference Manual

7.1.12 port-channel

Interface Config commands
Use this command to select the load-balance criteria of a aggregated port. This command
Syntax
port-channel (load-balance [src-dst-ip|src-dst-mac])
Parameters
load-balance
[src-dst-ip|src-dst-mac]
Usage Guidelines
Use this command to configure and set the load balance to the aggregated port created using
static-channel-group
Example
The example below creates a channel group 1 with interface ge1 and ge 2.
RFS7000(config)#interface ge1
RFS7000(config-if)#static-channel-group 1
RFS7000(config)#interface ge2
RFS7000(config-if)#static-channel-group 1
The example beow select the load balance based on IP or MAC address.
RFS7000(config)#interface sa1
RFS7000(config-if)#port-channel load-balance src--dst-ip
RFS7000(config-if)#
Sets load-balancing for port channel.
• src-dst-ip – Source and Destination IP address based load balancing.
• src-dst-mac – Source and Destination MAC address based load balancing
.
7-15
(config-if)