Gas Installation - Electrolux T4900 Installation Manual

Gas installation

To be carried out by
qualified personnel
Install a manual gas shutoff valve upstream
from the dryer.
The gas connection to the dryer should be
dimensioned to an output depending upon the
kW-rating of the dryer.
The factory nozzle pressure setting must
correspond to the fuel value given on the data
label.
Check that the nozzle pressure and fuel value
agree with the values given in the table. If not,
contact your gas supplier.
Bleed the pipe system before connecting the
dryer.
After connection, test all joints for leaks.
Test run
Note! To ensure the correct amount of air to
the combustion, plate A must be mounted
before starting the dryer.
Loosen the measuring branch screw (2) 1/4 of
a turn.
Connect a manometer to the measuring branch
(2), (See page regarding gas valve).
Fill garments into the drum.
Select a programme that uses heat.
Start the dryer.
Check the nozzle pressure, see table.
If necessary, adjust the setting screw (4) of the
regulator under the cover screw (3).
Check that the gas is burning evenly and with a
bluish flame.
Function check
The function check is described in the back of
this manual.
Installation manual
1
A
Note
Before installing dryer with tilt
see section "Dryer with tilting
function".
19