Installation & Initial Startup - PROLiNK PRO700SFT Quick Start Manual

4. Installation & Initial Startup
Note:
Before installation, please inspect the unit. Be sure that nothing inside the package
is damaged.
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best results,
suggest to charge the battery at least 6 hours before initial use. The
unit charges its battery while connecting to the utility.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow. Please
place the UPS away from other units at least 20 cm to avoid interference. DO NOT operate the
UPS where the temperature and humidity is outside the specific limits. (Please check the specs
for the limitations.)
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the power
switch of UPS unit, and then devices connected to the UPS will be protected by UPS unit.
CAUTION:
NEVER connect a laser printer or scanner to the UPS unit. This may
cause the damage of the unit.
Connect Communication Cable
Connect Communication Cable (only applicable for the models with USB port)
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the
power switch.
20cm 20cm
6 Hours
EN 4