Squeegee (Initial Fitting) - HAKO Scrubmaster E10 Instruction Manual

Description
Dismount Brushes
Use the support roller located at the
G
front side of the Hakomatic to set
the machine into its park position.
Loosen slotted screw by means of a
G
coin.
Open brush cover and remove bru-
G
shes. Re-close cover and tighten
slotted screw.
When inserting the brushes
for the next operation, make
sure to change position of
the brush such that one-
sided brush wearing is pre-
cluded.
14
Brush Maintenance
Remove fresh and soiled
G
water tanks
Use the support roller located at the
G
front side of the Hakomatic to set
the machine into its park position.
Use the adjustment screw to set the
G
operating handle of the machine into
vertical position, and then tilt the
machine down as represented.
Loosen slotted screw and fix the
G
brushes manually as represented in
Fig. 2 in direction 1.
Open brush cover in direction 2.
G
Remove brushes
G
Clean brush compartment
G
Insert brushes, close brush cover
G
and secure with slotted screw.
Set Hakomatic in upright position.
G
Use adjustment screw to set the
G
operating handle into working posi-
tion.
Fig. 1
Set front support roller into working
G
position.
Re-insert fresh and soiled water
G
tanks.
Squeegee
Fig. 2
The Hakomatic E 10 has been
equipped with a squeegee of 450mm
working width. The squeegees can be
lifted-out alternately.
Check the squeegee for col-
lected foreign particles and
for proper condition before
start of operation.