Fitting The Front-Mounted Equipment - HAKO Citymaster 2200 Operating Manual

Operation
3.3.2

Fitting the front-mounted equipment

B
18
105
168
169
Fig. 88:
122
Observe the Safety instructions – Attachments in general, see page 121.
A
Note
Attachments can only be fitted to the Citymaster 2200 with the
winter service option. Two possibilities are available:
•
•
1. Lower the front tool carrier Fig. 88-18 with the tip switch Fig. 88-105
and secure the vehicle against rolling away.
2. Remove the hexagon bolt and the washer Fig. 88-A of the front tool
carrier.
3. If necessary, slightly tilt the front tool carrier forwards with the upper
link Fig. 88-B.
4. Drive slowly and straight ahead with the front tool carrier underneath
the bracket for the attachment.
5. Slowly raise the front tool carrier with the tip switch Fig. 88-105.
6. When raising the front tool carrier, make sure that it sits correctly in the
bracket for the attachment.
7. Install the hexagon bolt and the washer Fig. 88-A to secure the front
tool carrier.
8. If fitted, remove the outrigger supports of the front-mounted equipment.
9. Make the connections.
Adjusting the lowering speed of the front tool carrier or the
external lifting device (option)
The suction mouth has been removed (with 2-brush system):
•
The lowering speed of the front tool carrier is adjusted using the throttle
valve Fig. 88-168. The throttle valve is located behind the cab on the
right-hand side.
C
The suction mouth has been removed (with 3-brush system):
•
The lowering speed of the front tool carrier is adjusted using the throttle
valve Fig. 88-C. The throttle valve is located behind the cab on the
right-hand side.
The suction mouth remains in the vehicle and an external lifting device
•
(option) has been fitted:
The lowering speed of the external front tool carrier is adjusted using
the throttle valve Fig. 88-169. The throttle valve is located under the
cab on the right-hand side. The suction mouth must be locked in the top
position using the throttle valve Fig. 88-168 or the throttle
valve Fig. 88-C.
The suction mouth remains in the vehicle. In this case, the
front tool carrier and thus also the suction mouth are raised
and locked in the top position. The raise and lower function
of the front-mounted equipment is then realised via an
external lifting device (option).
The suction mouth is removed. The raise and lower
function of the front-mounted equipment is then realised via
the front tool carrier.
03-1481-00-00.fm