Appendix; List Of Messages - Sony BRC-Z330 Operating Instructions Manual

Appendix

List of Messages

The following messages may appear on the screen. Take
the necessary measures shown below.
Indicators on the BRC-Z330 camera
Indicator Meaning/remedies
STANDBY lamp The camera stopped moving due to an
flashes. error in the pan/tilt mechanism. Reset
the pan/tilt position or turn off the power
of the camera and turn it on again.
The tally lamp Turn off the power of the camera, and
flashes. consult with your Sony dealer.
Messages for the BRC-Z330 camera
Message Meaning/remedies
Please restart system You are prompted to restart the power of
the camera after you changed the setting
of "IMG-FLIP" in the SYSTEM menu.
Use the POWER switch on the supplied
Remote Commander or the POWER
button on the RM-BR300 Remote
Control Unit to turn the power off, then
on. The changed setting becomes
effective.
PRESET xx OK When you store the camera settings into
(xx = preset position the memory (POSITION 1-16), the
numbers 01 to 16) message will appear for 2 seconds.
One Push WB...OK While the white balance is automatically
(NG) adjusted, the message will appear. Wait
for a while. When the adjustment is
complete, it will disappear.
STOP Turn off the power of the camera, and
(The message will consult with your Sony dealer.
flash in FAN
MOTOR on PAGE6
in the STATUS
menu.)
CAUTION Turn off the power of the camera, and
COOLING FAN consult with your Sony dealer.
STOPPED!
*[ENTER]: EXIT This message appears while you adjust H
PHASE in the SYSTEM menu. To exit
from the adjustment, press the HOME
button on the Remote Commander or the
button on the top of the joystick on the
Remote Control Unit.
*PUSH ENTER This message appears when you move
BUTTON the cursor to H PHASE in the SYSTEM
menu. To start the H PHASE adjustment,
press the HOME button on the Remote
Commander or the button on the top of
the joystick on the Remote Control Unit.
Message Meaning/remedies
PRESET (xx) OUT This message appears when you preset
OF RANGE (xx = the camera position when the pan/tilt
preset position position of the camera is out of range of
numbers 01 to 16) the current PAN-TILT LIMIT setting.
This camera position presetting will fail
to be performed. Perform the presetting
again after moving the camera within the
range of the PAN-TILT LIMIT setting.
Messages for video outputs from the BRU-SF10
HD Optical Multiplex Unit
Message Meaning/remedies
Communication • The AC adaptor is not properly
error connected to the DC IN 12V
Please check connector on the BRC-Z330, or the
connection AC cord may be disconnected from
the power outlet. Check that the
BRC-Z330 is turned on.
• The CCFC-S200 Optical Fiber Cable
connecting the BRC-Z330 to the
BRU-SF10 is connected improperly,
or the optical fiber cable may be
damaged.
• Image frequency settings for the
BRC-Z330 and the BRU-SF10 may
be different. For details on settings,
see page 20 and 27. After checking
the above conditions, restart the
BRC-Z330 and BRU-SF10.
Option card error This message appears when an
Please check option unsupported optional interface card is
card inserted in the card slot of the
BRU-SF10. Remove the card after
turning off the BRU-SF10.
69
List of Messages