Loading Paper In Trays 6 To 7; Loading Paper In Interposer - Fuji Xerox DocuCentre 9000 Quick Reference Manual

4 Paper and Other Media

Loading Paper in Trays 6 to 7

Following describes the procedure for loading paper in the optional trays 6 to 7.
1
Pull out the tray towards you until it
stops.
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine processes
2
Load and align the edge of the
paper against the right edge of the
tray with the side to be copied or
printed on facing up.
Important • Do not load paper exceeding
4
3
Push the tray in gently until it comes to a stop.

Loading Paper in Interposer

Following describes the procedure for loading paper in interposer.
Interposer is meant for loading paper (blank, copied paper, etc.) to be used as
separators and covers, so it cannot copy.
Note
1
Hold the center of the paper guides
and slide them to the desired paper
size.
2
Load the paper, aligning to the front
side of the tray.
52
Warning
a job, do not pull the tray out
that the job uses.
the maximum fill line. Doing so
might cause paper jams or
machine trouble.
• When adding paper to interposer, remove any paper remaining in the tray, add it to the stack
of paper to be added, then load all of the paper into the interposer at once.
M A X