Installing The Blade - Roland VersaCamm VS-640i Setup Manual

6. Installing the Blade

CAUTION
CAUTION
1.
Insert a blade into the blade holder.

Insert the pin.
Insert the pin to the position where its end sticks out about 3 to 5 millimeters.
Insert the blade.
Insert the blade into the hole.
Pin
Cap
2.
Enter the blade replacement mode.

Press

w
x
NOW PROCESSING..
OPEN FRONT
COVER
y
38
Be sure to perform operations as specified by these instructions, and
never touch any area not specified in the instructions.
Sudden movement of the machine may cause injury.
Never touch the tip of the blade with your fingers.
Doing so may result in injury, and the cutting performance of the blade will be
impaired.
Blade holder
.
Press
left appears.
Press
Press
Press
Press
Open the front cover.
The cutting carriage moves to the position where the blade can be replaced,
and then the message on the left appears.
When this message appears, the reparation is complete.
Blade
several times until the screen shown on the
, and then press
.
twice.
.
twice.