Step 2: Installing The Media Holder - Roland VersaCamm VS-640i Setup Manual

Step 2: Installing the Media Holder

WARNING
Procedure

Place the shafts on the stand.

Pass the left media holder onto the shaft.
Pass it through from the right edge (as seen from the back of the machine).
w
Move the left media holder to the left side of the shafts and attach the retaining screw.
Only light tightening is necessary for the retaining screw.
Retaining
screws
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
Insert the front shaft into the
media holder.
Tighten
loosely.
Shafts
Place the media holder hanged
on the rear shaft.
3. Assembling and Installing
25