Preparing To Move The Machine; Step 1: Removing Media And The Blade Holder - Roland TrueVIS VG2-640 User Manual

Preparing to Move the Machine

Before moving the machine, dispose of the discharged fluid and secure the print heads in place. Attempting to
move the machine without first performing these preparations may result in damage to internal components due
to leaking ink or damage to the print heads.
IMPORTANT
• Once the preparations for moving the machine are complete, move the machine promptly and turn on the machine as soon as
possible after the machine is relocated. If you leave the machine alone without turning it on, the precipitated ink will coagulate and
result in problems such as the clogging of the print heads.
• When moving the machine, keep it at a temperature from 5 to 40°C (41 to 104°F) and at a humidity from 20 to 80% (with no
condensation). Failure to do so may result in a breakdown.
• Handle the machine with care when moving it, keeping it level (not tilted at an angle) and preventing it from striking other objects.
• After the printer is reinstalled, the media holder adjuster must be adjusted by a suitably qualified worker. This work must be per-
formed by a Roland DG worker. Contact your authorized Roland DG Corporation dealer.

Step 1: Removing Media and the Blade Holder

Procedure
1.
Remove any media.
If any media has been loaded, remove it.
If no media is loaded, raise the loading lever.
2.
Press [MENU].
3.
Press [▼] several times to display the screen shown below.
MENU
SUB MENU
4.
Press [▶] once, and then press [▼] several times to display the screen shown below.
SUB MENU
MAINTENANCE
5.
Press [▶] once, and then press [▼] several times to display the screen shown below.
MAINTENANCE
REPLACE KNIFE
6.
Press [ENTER].
The cutting carriage moves to a position where blade replacement is possible.
7.
When the following screen is displayed, open the front cover.
OPEN FRONT
Preparation is complete once the following screen is displayed.
FINISHED?
306
1. Operations When Moving the Unit
COVER