Protecting The Boot Manager With A Password - Nokia IP100 Series Installation Manual

Using Boot Manager

Protecting the Boot Manager With a Password

56
To prevent accidental or unauthorized access to the hard disk on your
IP100 Series NAP, you can require that the user enter a password to
access the install command in boot manager. Use the passwd
command to set the password.
The password you enter here is the password that gives
NOTE:
you access to the install command in boot manager, not
access to IPSO.
To set a password, perform the following steps:
1.
At the boot manager command prompt, enter the following:
BOOTMGR[0]> passwd
The passwd program asks you for your current password.
2.
If the NAP is protected by a password, enter your current password.
3.
The program asks you for the new password. Enter the new
password..
4.
The program asks you to re-enter the new password for verification.
Enter the new password again.
IP100 Series Installation Guide