Problems With Ospf; Ospf Does Not Operate - Nokia IP100 Series Installation Manual

Problems with OSPF

IP100 Series Installation Guide
Here is an example of screen output:
O 172.16/16 via 10.1.1.225, eth-sp4plcO,
cost 3, age 3111
Several trace options are also available. These can be enabled in Routing
Options in the Routing Configuration section in Voyager. When you
enable a trace, the output appears in /var/tmp/ipsrd.log.
Troubleshooting Tips
Use tcpdump to view routing information. To display routing updates
for specific interlaces, use this command:
tcpdump -i logical interface name proto ospf
(See Viewing Packets With tcpdump for more information about using
the tcpdump command.)
Under Routing Options in the Routing Configuration section in
Voyager, you can also enable several types of trace options for OSPF.
These traces are logged in /var/tmp/ipsrd.log.
Problem

OSPF does not operate

Possible Cause
OSPF is not configured.
Possible Solution
Verify that OSPF is properly configured for all interfaces that are
involved in OSPF routing. For more information, view Configuring
OSPF from the Configuring Routing page (press the
Voyager.
Routing Problems
D button) in
OC
79