24
Note these points:
•
There is no way to log out the user when the modem disconnects. If
you disconnect without logging out, the next dial-in user will not have
to log in. To eliminate this problem, set the autologout parameter
in the .cshrc file on the NAP to admin.
•
When you first connect to the modem, you might need to press return
a few times to get a login prompt.
•
If you appear to be experiencing problems with flow control, try
adding these AT commands:
&H0
&R2
Best Data 56K data fax modem
For the Best Data fax modem, follow these procedures:
A.
Pass this AT string to the modem:
AT&F&K4E0Q1S0=1
After entering this command, you will not see your own typing or
any response from the modem.
B.
Enter these two strings:
AT&W0
AT&Y0
Table 2-3 shows the meanings of some of these commands.
IP100 Series Installation Guide