Step 4-Entering Initial Interface Information - Nokia IP100 Series Installation Manual

Step 4—Entering Initial Interface Information
IP100 Series Installation Guide
If you select Option 1, go on to the next section, Step 4—Entering
Initial Interface Information. Skip the rest of the present section.
Option (Lynx) allows you to use Lynx to configure the NAP. Lynx is a
2
text-based browser that runs on the console itself. Lynx is supplied as part
of the IPSO software. Use Lynx only if you cannot connect to a LAN.
If you choose to use Lynx, the system startup procedure asks whether you
want to start Lynx now.
A.
Type Y (yes) to start Lynx.
B.
Choose Config (the default).
C.
Follow the procedures under Step 4 and Step 5 (below).
You can start Lynx at any time by entering lynx at the
NOTE:
command prompt.
A.
Select the interface you want to use to access Voyager to
configure the NAP over a LAN. System startup displays the physical
IDs of the NAP's interfaces. For the IP110 NAP, the display looks
something like Figure 3-3:
Select an interface from the following for
configuration:
1)eth-s1p1
2)eth-s2p1
3)eth-s3p1
Enter choice [1-4]:
Figure 3-3. System startup interface screen for IP110 NAP
Using System Startup
31