Eclipse Security Tribrid User Manual page 208

PTZ Here you can set PTZ movement when alarm occurs. Such as go
Activation to preset X. See Figure 5-54.
Video Matrix This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports
one-channel tour function. System takes "first come and first
serve" principle to deal with the activated tour. System will process
the new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
5.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-55.
After analysis video, system can generate a video loss alarm when the detected moving
signal reached the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest
setups, please refer to chapter 5.8.3.1.1 motion detect for detailed information.
5.8.3.1.3 Tampering
The tampering interface is shown as in Figure 5-56.
After analysis video, system can generate a tampering alarm when the detected moving
signal reached the sensitivity you set here.
For detailed setups, please refer to chapter 5.8.3.1.1 motion detect for detailed
information.
HDCVI Standalone DVR User's Manual
Figure 5-55
199