Aligning The Fireplace Cassette; Installing Or Dismantling The Firebox Into/From The Convection Air Jacket - Spartherm XS 500 Installation And Operating Instructions Manual

2.17 Aligning the fireplace cassette

In order to align the fireplace cassette, the
four feet can be adjusted from the side, front
or rear using a spanner to ensure that the
frame / firebox are level.
If it is necessary to align the fireplace
cassette at a later date then it is possible to
gain access to the feet through the firebox
itself. This involves dismantling the firebox
lining (see 2.22) and setting the adjustment
screws with a 6 mm Allen key.
(Not valid for linear cassette XS500)
1.) Green arrow: Height adjustment of the foot
2.) Red arrow: Height adjustment of the firebox
3.) Blue arrow: Locking the firebox in position in
4.) Yellow arrow: Positioning rectangle
If new settings have been made then it is
necessary to reinsert the floor insulation because
this guarantees that the holes are insulated from the room's air.
2.18 Installing or dismantling the firebox into/from
The firebox can be dismantled from the convection air jacket in its installed
state. Reasons for this include e.g. the retrofitting of a hot air blower.
However, the prerequisite for this is that the combustion air pipe is not fixed at
the rear of the cassette or that it allows sufficient movement of the firebox in a
forwards direction.
Process steps:
1. Dismantle the cassette frame (see 2.15)
2. Remove the firebox lining (see 2.22)
3. Loosen the firebox locking mechanism (blue arrow, see 2.16)
on the convection air jacket
in the convection air jacket
the convection air jacket
(transport locking device). This
must always be released when
the firebox needs to be aligned
the convection air jacket
framework PAGE - 27 -