Fundamental Requirements For The Installation/Use Of An Open Fireplace; Installation Location - Spartherm XS 500 Installation And Operating Instructions Manual

Linear fireplace cassettes
Table of Contents

Advertisement

2.2
Fundamental requirements for the installa-
All necessary national and European standards, as well as local regulations
in the German state (DIN, DIN EN, state building regulations, fire regulations
etc.) must be observed and applied for the installation, connection and
operation of the fireplace cassette. The following is a list of the relevant
regulations (without any claim to completeness).
FeuVo/LBO/VKF:
1st BlmSchV:
TROL:
DIN 1298 / EN 1856:
DIN EN 13229:
DIN 18896;
DIN EN 13384:
DIN 18160-1/2:
Fireplaces may only be installed in rooms and locations where no
danger results from their position, structural conditions and type of
use. The surface area of the installation room must be designed in
such a way and be large enough to ensure that the fireplace can be properly
operated in line with its intended purpose.
Fireplace cassettes are fireplaces that are dependent on room air. This
means that problems can arise when a ventilation system is operated at the
same time (e.g. cooker extractor hood, bathroom fan, etc.). In these cases,
suitable measures (e.g. low pressure monitor) must be taken to ensure that
safe operation is guaranteed.
General requirements placed on installation sites for fireplaces and
fireplace cassettes:
Fireplace cassettes may only be installed in rooms and locations where no
danger results from their position, structural conditions and type of use. In
particular, in the case of fireplace designs dependent on room air then
tion/use of an open fireplace
Fire regulations of the relevant federal state / state
building regulations or fire protection regulations of
the VKF (Switzerland)
First ordinance for implementing the Federal
Immission Control Act
Specialist regulations issued by the Tile Stove and
Air Heating System Association (ZVSHK)
Connecting flue pipes for heat generating systems
Inset appliances including open fires using solid
fuels
Fireplaces using solid fuels, technical specifications
for installation and use
Exhaust gas systems calculation method
Exhaust gas systems / residential chimneys
2.2.1

Installation location

framework PAGE - 10 -

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M 700Xl 900S 600L 800

Table of Contents